WatchUSeek Watch Forums banner

1 - 20 of 24 Posts

·
Registered
Joined
·
1,330 Posts
DIal cut.jpg DIal cut2.jpg
#
Seems that you go better and better with this.... ( I still stick to my machines.....) ( !Hats off! for your result)

Only thing - I dont like the drill cones at all - not the same technique and they disrupt all the effort you put into this....
try other things ... better cut diamonds or stars or similar things ... or place nail heads or rivets instead of the holes...
 

·
Registered
Joined
·
551 Posts
Discussion Starter #9
Thanks the dial was not done when I took the picture I did lume the holes
Im still in experimental stages.
I like your rose a lot.
 

·
Registered
Joined
·
1,330 Posts
You're right - even if a little more heritage ( especially in my case would not be wrong) .

A professional watchmaker and friend always comments my work ... this is recent fine mechanics, but no watchmaking in the traditional way at all - even if results would be the same!
 
1 - 20 of 24 Posts
Top