WatchUSeek Watch Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
3,819 Posts
Discussion Starter · #1 ·
Hi WUS,

I was wondering if anyone knew of the actual size screwdriver for the new speedy pro bracelet? I'd like to order one specific for the bracelet.

Thanks!
Jay
 

·
Premium Member
Joined
·
50,461 Posts
I would order a set instead of just one so you have other sizes as well like from .40 to 1.0, or similar.

I would guess this one will take the .60 or .80 the best, but again just a guess???

Good luck.

Others way smarter than I will chime in with the correct response.
 

·
Registered
Joined
·
3,819 Posts
Discussion Starter · #3 ·
I would order a set instead of just one so you have other sizes as well like from .40 to 1.0, or similar.

I would guess this one will take the .60 or .80 the best, but again just a guess???

Good luck.

Others way smarter than I will chime in with the correct response.
Thanks I have a set but they are like 10 years old and could use some new bits. I was planning on adding a new bit for just this watch. I don't have to size many watches nowadays. Usually just Rolex and some Omegas occasionally.
 

·
Premium Member
Joined
·
1,216 Posts

·
Registered
Lately: Omega Seamaster Professional Divers 300
Joined
·
5,026 Posts
Thanks I have a set but they are like 10 years old and could use some new bits. I was planning on adding a new bit for just this watch. I don't have to size many watches nowadays. Usually just Rolex and some Omegas occasionally.
So buy a new set of bits.


Just another watch nerd.
 
1 - 7 of 7 Posts
Top