WatchUSeek Watch Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
103 Posts
Discussion Starter · #1 ·
Hello, i just got a PO (see my thread with pictures: https://www.watchuseek.com/showthread.php?t=314423)

And i have a small question.

Yesterday, i was setting the date, and while switching between 2 dates, i accidently pulled the crown to position 3 to set the time. The date window got stuck between 2 dates. When i switched to crown to position 2 to set the date again, the crown was spinning but the date was not changing anymore. My heart just started pumping really hard at this point. So i set back the crown to position 3 to set the time again, and i manually change the time untill i reach 0:00h and miraculously, the date switched to a full number, not between 2 dates anymore.

So tonight, it was around midnight and i wanted to see the date changing and i saw that the datewheel was already starting to switch between the 2, as you can see on the picture, and 3 seconds after this picture, the date switched, not gradually. Is this normal? I tought the date would flip one shot.



This only happend at 11h59, then it switched at 00h00 and the date is in perfect position.

Question 2:

While switching the date, i discovered that on the number 9 and 19, there is a small white line on the date wheel, is this normal?



Thank you.
 

·
Registered
Joined
·
103 Posts
Discussion Starter · #4 ·
I did indeed changed the date several times between 8pm and 2am.... I have read the manual but forgot about this when i wanted to set the time exactly to the time on weather channel...

I hope it doesnt mess anything, the date changes fine , always between 11:59 and 00:00, everything is ok so far.

Thank you for your replies, i wont fiddle that much anymore :)
 
1 - 2 of 2 Posts
Top