WatchUSeek Watch Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
20 Posts
I know this is a resurrection of a fairly dead thread, but I've just (in the past few weeks) dropped off one of my babies (a 2531.80; pictures when it returns) at Fine Swiss Watch Service with Haris for a factory service and replacement of the crystal and bezel (somehow I managed to dent/chip the bezel and chip the crystal).

As it turns out, his workshop is only about one mile from my house so I was able to personally drop my watch off and see his shop. His facilities were in order (the workspace and equipment were clean and in good condition) and Haris himself was very friendly and very knowledgeable about what he was talking about (he carries the same passion about watches that most, if not all of us on this board do).

At any rate, this is just a pre-review as a follow up to the above posted review... I'll post a new, full review of this watchmaker and the services performed once the work is completed (I believe his time estimate was 4 to 6 weeks).
 
1 - 1 of 1 Posts
Top