WatchUSeek Watch Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
9,520 Posts
Have you tried laying the balance cock upside down on the bench, and placing the balance on and feeding the stud through? This way you can line up the stud and also the balance spring in the regulator pins, then tighten the stud screw, flip it over and install it on the movement. Depending on the watch this can be a bit easier than trying to coax the stud into place while it's all on the movement.

Cheers, Al
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top