WatchUSeek Watch Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
80 Posts
It appears that your watch was measured on a Witschi Chronoscope M1.

The columns on the left are the measurements taken. It shows the three positions that readings were taken. From left to right: Dial Position, Rate, Amplitude, Beat Error

The info on the right side is:

D maximal difference between the several test positions
XH average over horizontal test positions
X average over all test positions
DVH difference between vertical and horizontal average values
Xv average over vertical test positions
DV maximal difference between the vertical test positions

These readings look good. Why don't you set it, and wear it for a week or two? Hope you don't work in a magnet factory.:)

Steve
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top