WatchUSeek Watch Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
80 Posts
Discussion Starter · #1 ·
I have an OD GMT and want to change the strap. Could someone tell me what size of screwdriver is required to change the lug screws - I am guessing 1.5 mm but am not totally sure.

Thanks in advance
 

·
Registered
Joined
·
833 Posts
Depends if yours has the hex lug, which is a 1.5mm Allan key, or the normal screw head, in which case you'll need a jeweler's / hobbyist screwdriver set
 

·
Registered
Joined
·
80 Posts
Discussion Starter · #3 ·
Thanks - however, I do not have the hex screw but the "normal" flat screw lug. I need to buy screwdrivers and therefore would like to get the exact size required. Perhaps someone else can help.
 

·
Registered
Joined
·
476 Posts
I changed out the band on both my Prometheus Chron and OD, and used a small jewelers screwdriver. I had a set and just tried one till I found one that worked. I recall it being the smallest I had, but cannot give you the specific size.
 

·
Registered
Joined
·
80 Posts
Discussion Starter · #5 ·
Thanks for the feedback.
 

·
Registered
Joined
·
917 Posts
Thanks for the feedback.
Hey TaiTam - the exact size you will need is 1.6mm and you will need two screwdrivers. See my other post in the Benarus mesh thread.

Cheers

Mark
 

·
Registered
Joined
·
80 Posts
Discussion Starter · #7 ·
Thanks - this is exactly the answer I was looking for.
 
1 - 7 of 7 Posts
Top