WatchUSeek Watch Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey guys,

First experience with anything inside of a ready watch (literally never seen the inside of a watch other than through display casebacks) and planning on putting a skeletonized seagull 6947 clone from ebay in the ofrei #11/#10 case. Unfortunately I just joined so I can't post links so I hope I can describe the problem.

The screws that hold the dial feet looks to come with the movement according to that picture, however for fitting the movement in the case the ofrei description says "Simply install the case screws supplied with your movement, backing them off until they just touch the case back after a waterproof seal is made when closing the case tight".

What are these case screws? Do they always come with a movement even if it's someone random on ebay? If not how do you recommend I go about getting something that will accomplish this purpose? Also when it says "back it off", does it simply mean to unscrew it a bit so it sits flush with the case back when you put on the case back?

Thanks for your patience bearing with some intro 101 questions!
 

·
Registered
Joined
·
3,411 Posts
Pls below to identify the position.
Dial screw for the 6497 are usually secured on the main plate.

 
1 - 4 of 4 Posts
Top