WatchUSeek Watch Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hey all,


Any direction on what size screw pin I need for my TT1 bracelet, as seen here: imgur.com/5oLPwgX


Size? Method of replacing (screws out I assume?) Source for replacement screws?


Thanks!
J
 

·
Premium Member
Joined
·
60,727 Posts
No idea what size pin you need but if you look on th centre portion of the bracelet clasp there will be a model number marked on it. Contact the service centre in your country and explain how band xxxyyyzzz has shed a bracelet link pin and you're looking to replace it - can they help? I think that the pins on these are single end slotted and screw in from 1 side, I also think they are 1.5mm.
Once you have sourced the pin and fitted it keep an eye on it for escaping. If a good tighten won't keep it in place just the tiniest drop of low torque thread lock can be applied. Under no circumstances be tempted to use the high torque stuff.
 
1 - 2 of 2 Posts
Top