WatchUSeek Watch Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 · (Edited)
I have been scouring the internet trying to find the ideal quad+ watch winder for my dive watches, but I haven't find "the one." I currently have some Wolf Module 2.0 winders and they don't keep my watches wound and the horizontal loading causes them to sometimes fall out. Luckily none of my watches have been scratched yet. I've been looking for a winder that loads the watches flat or at an angle so there is no chance they can fall out. Any suggestions would be helpful. I have some panerai, doxa, uts, sinn, etc.
 

·
Registered
Joined
·
980 Posts
I use the Brookstone 4 watch winder. Only cost $200 and it works great. I don't have any huge watches, but the 44mm ones in my collection fit just fine. The watches sit at an angle and will not fall out. 100% security. I also have a single Wolf winder. It's from the lower end of the Wolf range. The Brookstone winder is much better.
 
1 - 2 of 2 Posts
Top