WatchUSeek Watch Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,141 Posts
Discussion Starter · #6 · (Edited)
You can also make a tool for these in a few minutes. Use some peg wood and taper the end diameter so it's the right OD, and use a small drill to create a recess in the tip - works like a charm...
I found a couple of Bulova 11afc plates in the spares draw with same springs so I'll make one up and have a practice. Thanks
 

·
Registered
Joined
·
1,141 Posts
Discussion Starter · #8 ·
Your absolutely right James,
I practiced on the 11afc using Archers idea (works great) and thought initially it was jammed at one corner then realised I could swing it up. I could see the wire it is attached to in the Tudor under magnification. Here is the opened 11afc.
Gear Bicycle part Auto part Machine Metal
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top