WatchUSeek Watch Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter #1
Apologies if this has been posted before. I did a search but no luck.

When changing the bracelet on an SMP how do I get at the spring pins? Are the metal covers on springs or something?

I think they must be, but want to check before I trash the watch!

Thanks

Traps
 

·
Registered
Joined
·
45 Posts
Discussion Starter #2
Ok I will be more specific.

How do you actually get at the pins? There is a VERY small space (way too small for my pin remover to fit through), through which you can see the groove that the remover dovetails into.

Do you remove the things that "cover" these before removing, or is the remover simply too big?
 

·
Registered
Joined
·
9,532 Posts
It sounds like...

It sounds like the tool you're using is too large. Sorry, I don't have a better photo, but here's the size you should be looking for.



eric
 

·
Registered
Joined
·
45 Posts
Discussion Starter #4
Ah Thanks Eptaz, much appreciated.

Yes you're right, the tool I have is way too large. Looks like there is nothing to "snap up" on the back.

Again, thanks for the response.
 
1 - 4 of 4 Posts
Top