WatchUSeek Watch Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
321 Posts
Discussion Starter #1
All

I am registering for the Level 1 TZ Course, and rather than taking the basic case, crystal, etc, I am picking these items a la carte. I am putting together various dial/case/hand combinations said watch, but the pieces need to fit a Unitas 649*. I'm looking for the following hands to fit the movement:



It is my understanding the hole size for the 649* is 115/200; the one pictured above is 90/150. I have been looking at TZ and Ofrei... can anyone make any recommendations? Can I bore the hole to be bigger or would I be committing hand homocide?

Also, I would like to use a 41mm case, but the opening is 36mm and the dial I've selected for one scenario is 36.5mm. Will I be running into any major complications going with this combination?

Thanks
 

·
Registered
Joined
·
321 Posts
Discussion Starter #3
No, I haven't, pithy. Actually, I didn't even think about it. I'll ask today.


Sent from my lucky rocketship underpants
 

·
Registered
Joined
·
321 Posts
Discussion Starter #5
Thanks, mike
 
1 - 5 of 5 Posts
Top