WatchUSeek Watch Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
:) I have been given a Tag watch with number CA1211-Ro stamped to the rear, unfortunately it is running behind time. Could someone pass on the instructions on how to set the time correctly and operate the Chronograph:thanks.
 

·
Registered
Joined
·
1,127 Posts
:) I have been given a Tag watch with number CA1211-Ro stamped to the rear, unfortunately it is running behind time. Could someone pass on the instructions on how to set the time correctly and operate the Chronograph:thanks.
This one should be easy. Unscrew the crown and pull to position 1 (sets date), position 2 sets time. When you pull the crown to position 2, it should hack the second hand (small subdial at 6:00). Rotate the crown to set the hour and minute hand.

To start the chrono, press the top pusher (A pusher). To stop the chrono press the A pusher again. Now the chrono can be restarted by pushing the A pusher or reset to "zero" by pushing the lower pusher (B pusher). If the chrono does not reset to "zero" properly, you can unscrew the crown and pull to position 1 & 2. Pressing the A & B pushers while the crown is in position 1 & 2 will advance the chrono hands (large white second hand, large red minute hand, 1/10 subdial and hour subdial). Can't remember which one does what exactly, but you should be able to figure it out. It's very common to have to reset the chrono hands after changing the battery. Hope this helps.
 
1 - 2 of 2 Posts
Top