WatchUSeek Watch Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
589 Posts
You can zero each of the hands on the chronograph dials individually. Here's how:

1) Make sure the chronograph is stopped.

2) Reset the chronograph with the pusher at 4 o'clock. If any of the hands aren't at their "zero" position they'll need to be adjusted.

3) Pull out the winding crown to the first position (date setting position).

4) Push the plunger at the 2 o'clock position. This will advance one of the chrono hands a step at a time. Stop it when the hand is at zero.

5) Push the plunger at the 4 o'clock position. This will adjust another of the chrono dials.

6) Pull the crown out to the second position (time setting position) and use the 2 or 4 o'clock plunger to adjust the final chrono dial.

One of the 4 possible crown/plunger combinations doesn't adjust anything. I don't have a chrono with me at the moment so I'm not sure which crown/plunger combination is the non-functional one. Anyhow, I hope this helps.
Does this only apply to quartz watches? In other words, can the same procedures be done on an automatic? I didn't know about this either. Thanks for the info.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top